DSI ITB setup balance distribution block




Balance distribution block setup for MAP sensor, to be used with our ITB kit. This stabilizes the MAP reading. They are made with stainless steel, TIG welded. This setup is specifically made to go with our Heat shield ver. III. Those hoses are special heat resistant braided hoses handling up to 300F so more than plenty for use. 8 threaded holes. This is a DSI product, so yes, when you connect a hose from this balance distribution block to the MAP sensor, the hose will fit straight. You can fit MAP sensor either on the right or on the left, or both.

Kit consists of the stainless steel balance distribution block, special heat resistant braided hoses, and AN fittings. Must use with the DSI/Jenvey manifold as well as with our Heat shield version III and MAP sensor kit.


You may also like…